Industries
We supply components for energy, rail, hydraulics and pneumatics, mechanical and plant engineering, industrial automation, heavy equipment and instrumentation.
-
01
Energy
Flanges, housings, shafts and sealing components for rotating equipment and pressurised plant. They bring the material certificate and batch traceability with them, and sealing faces call for a controlled surface finish, not merely a dimension.
-
02
Rail
Bushings, axles, fastening components and drivetrain parts. Here the documentation weighs as much as the part: a stable process, dimensional control on every batch and traceability back to the heat number - asked for not at the end but from the first article.
-
03
Hydraulics and pneumatics
Valve bodies, pistons, rods, fittings. The sealing dimensions decide: close tolerances on diameters and a fine finish exactly where the seal runs - the rest of the surface may stay rougher without doing any harm.
-
04
Mechanical and plant engineering
Brackets, flanges, shafts, plates, covers - the branch with the widest variety of parts and the smallest runs. What governs is set-up time, not cutting speed: a part in ten pieces is paid for in fixtures and tooling, not in minutes of cutting.
-
05
Industrial automation
Small and medium parts, many with precisely located holes and faces in several directions. Relative position matters more than absolute size - which is why a single setup is worth more here than a heavier feed.
-
06
Heavy equipment
Large parts, often in quenched-and-tempered steel, with a heavy roughing allowance. Machine travels and fixturing stiffness decide, and stress relief of the sawn blank, ahead of machining, is not optional: otherwise the stresses released in roughing move the part before finishing.
-
07
Instrumentation and measurement
Small parts with fine dimensions and clean surfaces, often in stainless steel or brass. Here dimensional stability matters more than strength: the material, its condition after machining and the temperature at which it is measured change the result more than the tool does.
Work is carried out to the customer drawing. A sector not listed here is no limitation: what governs the quotation is the part on the drawing, not the sector label.
What a procurement department checks
A sector classification says little about a supplier. The questions asked before an order are the same whatever the branch, and the answers belong on the website rather than in an email exchange. The list below shows where each answer sits.
- Checked in: Work envelope - whether the part fits Where the answer sits: Diameter and length per machine, with an interactive check. 20 units
- Checked in: Material traceability Where the answer sits: EN 10204 certificate per batch and tracing back to the heat number. EN 10204
- Checked in: First article and dimensional report Where the answer sits: First article inspection before the series is released, dimensional report on delivery. AS9102
- Checked in: In-house dimensional inspection Where the answer sits: Coordinate measuring machines in the flow, not at a third party. 2 units
- Checked in: Materials and grades machined Where the answer sits: The families and grades, with the availability of each. 17
- Checked in: Quality management system Where the answer sits: The ISO 9001 certification, with its issuer, number, dates and scope.
- Checked in: How to request a quote Where the answer sits: A form with drawing upload, no account and no intermediary.
Each row leads to the page where the answer is written with figures.
The sectors we serve
The sectors are listed because they show what kind of parts routinely pass through the shop. They are not a commercial argument: a hydraulics part and an automation part can call for the same tolerance and the same traceability, and what governs remains the drawing, not the branch.
Request a quote
Drawings are submitted through the form below. The quotation follows within 48 hours, and the documentation submitted remains confidential.
Send a drawing