Industrial automation
Small and medium parts, many with precisely positioned holes and faces in several directions. What decides is not the tolerance of one dimension but the position of one dimension relative to another.
Parts typical of this sector
Small and medium parts, many with precisely located holes and faces in several directions. Relative position matters more than absolute size - which is why a single setup is worth more here than a heavier feed.
Criteria that govern the quotation
Position tolerance between features degrades at every repositioning of the part. Two faces machined in two set-ups inherit the set-up error, however precisely each is machined on its own. Parts with a bolt circle and angled faces are therefore finished in a single set-up on the simultaneous 5-axis centre: the dimensions between features remain the machine’s, not the operator’s. Dimensions taken between features are marked as such on the drawing, distinct from those referred to an edge.
Usual materials
The material groups most frequently found in this sector’s parts. What governs remains the requirement on the drawing, not the sector classification.
Usual processes
The processes this sector’s parts usually pass through.
Documentation usually required
Usual: a dimensional report on the position dimensions, measured in coordinates. Material certificate on request.
Request a quote
Drawings are submitted through the form below. The quotation follows within 48 hours, and the documentation submitted remains confidential.
Send a drawing